AW DESIGNAI × Architecture practice
Facade pattern study · Hobby project

Podium Pattern Studio 平台外牆圖案工作室

Set up a podium elevation, then let a few simple rules decide how open each perforated panel or fin is: points you drag, the way the facade faces, what each floor is for, and a privacy mask you paint. Then cap the number of panel types, and the gradient snaps to sizes a fabricator can actually make. Export the panel layout as SVG and layered DXF, and the panel schedule as CSV. The kind of study that used to need Rhino and Grasshopper, in your browser.

PanelsPerforated (round holes) or vertical fins
DriversPoints, orientation, floor use, painted mask
ExportsSVG, DXF (a layer per type), CSV, PNG
Start from

FloorUseHeightPanelsOpen area

Open area = holes (or gaps between fins, seen straight on) over the screened panel area of that floor, keep-clear zones left out. It is a number only: the tool states no ventilation or other statutory requirement. Check car park ventilation against current Buildings Department guidance and with your building services engineer.

1. Facade

Floors, ground first

Keep clear: pick the mode above the elevation and drag a rectangle over a shopfront, entrance or sign. Panels whose centre falls inside are left out. Tap a zone in that mode to remove it.

2. Panel

3. Drivers and weights

Car park and plant floors lean open, retail leans solid.

4. Panel types
TypeOpenCount

5. Export

Millimetres, origin at the bottom left of the elevation. DXF: one layer per panel type (outline plus its holes or fins), plus keep-clear zones, floor lines and labels. Everything is made inside this page; nothing is uploaded.

How it works
  1. Grid. The elevation is cut into modules: equal columns across the width, and a whole number of rows in each floor, as close to your module height as the floor allows.
  2. Drivers. Each panel gets an openness from 0 (solid) to 1 (open) from each driver. Points: closeness to the nearest point, eased over the reach. Orientation: a simple sun exposure proxy, highest facing south west, a little higher towards the top. Floor use: open for car park and plant, solid for retail. Mask: what you painted, where you painted it.
  3. Mix. The drivers are averaged with your weights. A driver with no say at a panel (no points, nothing painted there) is left out of that panel's average. The result is then stretched, so the most solid panel gets your "most solid" open area and the most open panel gets "most open".
  4. Snap. The smooth result is snapped to N types: equal steps between the most solid and the most open, or equal numbers of panels per type. Each type is one hole diameter (rounded to the millimetre, same pitch) or one fin angle (in 5 degree steps), so it is one punching tool or one bracket.
  5. Check. Types used by fewer than 3 panels are flagged: a fabricator will ask whether they are worth a separate tool. Panel sizes differ between floors of different heights, so the schedule also counts each size and type pair.
Limits
  • SunThe orientation driver is a design proxy, not a solar radiation or daylight result. It knows nothing about neighbouring buildings or shading.
  • FlatOne flat, rectangular elevation. No curves, corners, setbacks or panel joints beyond the module grid.
  • FabricationHole sizes and fin angles are geometry only. Edge distances, bridge widths, sheet thickness, fixings and tolerances are for your facade engineer and fabricator.
  • RegulationsThe open area figures are numbers only. The tool states no ventilation, fire or other statutory requirement.

A free hobby tool. None of it replaces a professional answer.

Credits